SuperSleeve™ HDPE Pile Sleeves Stand Strong at Snook Bight Marina

SuperSleeve™ HDPE Pile Sleeves Stand Strong at Snook Bight Marina

Last week, we revisited Snook Bight Marina in Fort Myers Beach, FL, to check on the performance of our SuperSleeve™ HDPE Pile Sleeves. Installed by Gorman Marine Construction on 16” OD steel piles with Golden Boat Docks, these sleeves were put to the test after enduring two hurricanes. The result? Zero damage—proof of their durability and reliability.

Our SuperSleeve™ HDPE Pile Sleeves LC200 (.200″ thick) are designed to fit steel, fiberglass, or concrete piles measuring 12” or greater in diameter. Manufactured in Houston, TX, the sleeves are pre-fabricated, easy to install, and equipped with fuse-welded caps to create a seamless, rust-free system.

From their robust design to their proven resilience, our pile sleeves are engineered to protect your investments, no matter the conditions.

Pile Sleeves for a Utility Crossing In Key West Florida

A barge struck the Utility crossing from Key West onto Fleming Key. The project location was within US Navy property. The aerial crossing supported all the waste water for Key West and was at risk of collapsing after both piles on the struck bent were broken through. The contractor, Ebsary Foundation, mobilized to install emergency temporary support to take the weight off of the compromised support. Then the permanent cased augercast pile repair was initiated.

Three new dolphin clusters were also installed to prevent damage to vital infrastructure in the future. The city of Key West selected the Lee Composites LC120 HDPE Pile Sleeves Gray/Black x 35’ length to fit 14”OD steel piles. The reasons were: to provide corrosion protection to the steel pile, protect the pile from abrasion, and to allow the pile sleeves to blend in with the concrete bridge piling.

Due to project conditions, which included constant boat traffic, strong currents, and coordination of a city emergency project on Navy property, a fast and reliable solution was made to use the LC120 HDPE Pile Sleeves.

The LC120 & LC187 HDPE Pile Sleeves provide the following benefits:

  1. Pre-fabricated in Houston, TX factory
  2. Colors: Black & Light Gray
  3. Lead Time: approx. 2-3 weeks
  4. Made to fit most any consistent size OD pile (steel, fiberglass, concrete)
  5. Multiple lengths available
  6. Made from virgin high density polyethylene
  7. Ready to slide down the pile for final assembly (hardware not included)
  8. Can be turned to get better surface area over time or flipped from bottom to top